W4-72 High-Temperature Centrifugal Fan

The W4-72-11 high-temperature fan is suitable for conveying non-corrosive high-temperature gases with a maximum temperature not exceeding 550°C. The gas shall contain dust and hard particles no greater than 150 mg/m³.

Phone:86-400 - 6878 - 808, ext. 2| Email:cici@xhygk.com

Phone:86-400 - 6878 - 808, ext. 5| Email:wea@xhygk.com

Phone:86-400 - 6878 - 808, ext. 4| Email:wtb@xhygk.com

Email: jennifer@zcpc.net

Get a quote

Usage

Form

This fan features single-sided air intake and a cantilevered structure. The fan is driven by a C-type transmission.

The fan can be manufactured in two types: right-rotating and left-rotating. When viewed from the end of the motor, if the impeller rotates clockwise, it is called a right-rotating fan; if it rotates counterclockwise, it is called a left-rotating fan.

Structural features

① Impeller—Composed of 10 backward-curved, airfoil-shaped blades, a curved front disc, and a flat rear disc, all made from heat-resistant stainless steel.

② Air inlet—Made as a single piece and mounted on the side of the fan, with a curved cross-section parallel to the axial direction, allowing gas to enter the impeller smoothly with minimal losses.

③ Drive Assembly — The drive assembly consists of a main shaft, pulleys, and a water-cooled bearing housing.

Keywords:

W4-72 High-Temperature Centrifugal Fan

Category:

Industrial centrifugal fan

Recommended Products